Magnetic Charging Dock Station with Batteries for Quest 2 Glasses Headset Handle Controller Charger Stand VR Base Accessories Parts Replacement Specification: Battery type: Lithium polymer battery Battery capacity: 1800mAh Grip battery life: about 36 hours Charging current: Helmet: Max 1.4A Handle: Max 500mA Charging time: helmet: about 3.5 hours handle: about 2.5 hours Dock charge indicator: Standby mode: green light Charging: Yellow light Full: green light Required charger output: 5V>2A 1. When the charging stand charges the VR helmet and two handles at the same time, in order to provide sufficient current, the charging stand must be equipped with a charger with an output of more than 5V2A 2. The original charger provided for Quest2 package can be used for this charging stand. Steps to charge the helmet: 1. Connect the charger above 5V2A to the charging seat (the charger is not included in this package, the customer needs to purchase it separately). The charging seat turns on the green light and enters the power-on standby state 2. Insert the Type-C magnetic head into the charging hole of the helmet 3. Put the helmet vertically into the corresponding charging position of the charging base. When charging starts, the charging LED indicator lights yellow. Steps to charge the handle: 1. Connect the charger with 5V2A or above to the charging seat (the charger is not included in this package, customers need to purchase it separately). The charging seat turns on the green light and enters the power-on standby state. 2. Slide the battery cover of the handle down and take out the battery cover. 3. Install the battery for the handle. When installing, please pay attention to the Type-C charging port of the battery as far as possible. 4. Install the battery cover provided in this package on the handle. 5. Use the needle provided in this package to adjust the Type-C charging port of the battery to align with the hole of the battery cover. 6. Insert the magnetic head into the Type-C charging port of the battery through the hole of the battery cover. 7. Put the handle into the corresponding charging position of the charging base and let the magnetic suction head contact. When charging starts, the LED indicator of the base will light up yellow (please note that the handle is divided into left and right, please refer to the L and R mark to place the handle). If you want to take out the magnetic head of the handle, please use the needle provided in the package to pick out the magnetic head. Note: Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you! Please allow 1-2cm measuring deviation due to manual measurement.

1*Charging Stand 2*Battery 2*Battery Cover 1*USB Type C Magnetic Head 1*Magnetic Head Pin 1*1.2m Charging Cable 1*Instruction Manual