Introduction of production steps 1. Please refer to the comparison table on the canvas to identify each diamond core Corresponds to the print area on the canvas 2. Insert the round end of the dispensing pen into the dispensing. (Pushing the cement hard in other directions may fall) 3. Use the diamond at the round end and press it lightly to remove the excess cement. 4. Tear off part of the film, and then paste the diamond on the canvas according to the corresponding number. 5. If it is attached to the wrong place, please use tweezers to remove the wrong diamond. 6. After trimming, lightly press the diamond to make it firm.

Diamond supplement service We will resend all diamonds you may have lost. About color difference and size error 1. The cutting, design and production of photos, the size of the canvas may cause size deviation (fluctuations of 1-2cm), after receiving the diamond painting, please purchase the photo frame according to the size of the diamond painting. 2. All our photos are made by software. The color of all actual diamonds will have some color difference in the rendering, but it should be within a reasonable range. Please understand that.